Turn on the heating elements by means of the rocker switches on the side panel. When the heating elements
are on the switches will illuminate. For maximum heat output both switches should be on.
When the desired room temperature has been reached, the thermostat knob should be turned slowly anti-
clockwise until the thermostat is heard to click off and the lights on the element switches are seen to go out.
After this the heater will keep the air temperature in the room at the set temperature by switching on and off
automatically.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry
place.
WALL- MOUNTING THE HEATER
Caution: - there should be a distance of at least 40 cm between the lower part of the appliance and the floor.
- the feet must be removed before mounting the appliance on the wall
1. Measure the distance between the two slots situated at the back of the appliance (see picture A)
2. Drill two holes at the same distance in the wall and insert a plug in each hole you just drilled. Place the
brackets facing the holes as indicated on picture B and attach them in this position with the screws
supplied.
3. Before attaching the appliance on the brackets, attach the two other brackets underneath the appliance as
indicated on picture C.
4. Attach the appliance on the wall. To do so, hold it in such way that the slots are facing the brackets; insert
the appliance halfway onto the brackets until the appliance can go down into the grooves of the brackets.
5. As soon as the appliance is positioned correctly, take a pencil and mark a dot in the hole of each bracket
situated underneath the appliance.
6. Then take off the appliance by proceeding the other way around compared to point 4 above.
7. Drill a hole in the wall on each dot you just marked and insert a plug in each hole.
8. Attach the appliance back on the wall as indicated in point 4, insert screws through the brackets
underneath the appliance and tighten without forcing.
Wall-mounting
A
X 2
B
