When the desired room temperature has been reached, the thermostat should
be turned slowly anti-clockwise until the thermostat is heard to click off and
the indicator light on the side panel is seen to go out. After this the heater
will keep the air temperature in the room at the set level by switching on and
off automatically.
PROTECTION AGAINST OVERHEATING
− An additional fitted safety thermostat protects the heater against
overheating and switches it off automatically. The service lamp then
goes out.
− If the device switches itself off, disconnect the mains plug from the
socket. The heater is ready for service again after a short cooling-off
phase (approx.15 minutes). Plug the mains plug back into the socket.
− If this repeats itself, first check whether the thermostat switch is set
correctly or if any objects hinder the heating operation.
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow it to cool down
before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a
dry cloth. Do not use any detergents or abrasives and do not allow any
water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time, it should be protected
from dust and stored in a clean dry place.
Note: this appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
