4
/
4
P/N 1073619-EN
• REV
A
• ISS 06MAR19
Refer to the
User M
anual
or click the
Help
button for further
information about using the web management interface.
Note
:
For security purposes, change and memorize the new
password after this first setup.
Saving the configuration
The running configuration file is stored in the RAM of the
managed
switch. In the current version, the running
configuration sequence of running
-
config can be saved from
the RAM to FLASH by executing the Save Startup Config
command. After doing this, the running configuration sequence
becomes the startup configuration file
(i.e.,
the saved
configuration)
.
To save all applied changes and set the current configuration
as a startup configuration, the startup
-
configuration file is
loaded automatically across a system reboot.
1. Click
System
>
Save Startup Config
.
2. Click the
Save Configuration
button.
Resetting the switch to default
To reset the IP address to the default IP
address
“192.168.0.100”
and the use
r
password to factory default mode
(default password is
“admin”
), p
res
s the hardware reset button
on
the front panel for about
10
seconds. After the device is
rebooted, log
in to
the management web
interface within the
same subnet of 192.168.0.xx
and default password.
Note that
all the previous setups
are erased
after the factory default
reset.
Note:
The managed switch security feature requires a change
to the default username and password (see
“
Start
ing
web
management” on page 3
) after performing a factory reset. We
recommend storing your configuration file for upload to the
switch (see
“
Saving the configuration
”
above) in case you lose
your password.
Figure 12: Reset button
Contact information
North America
T
+1 855.286.8889
E
W
www.interlogix.com/support
Latin America
T
+1
561
-998-
6114
E
Europe, Middle East, and Africa
W
Select
Contact Us
at www.firesecurityproducts.com
Australia
E