Installation
8
Verify that the
Power
LED is on and the
Run
LED is blinking.
To address the VAV Zone Controller
You must give the VAV Zone Controller an address that is unique on the network. You can address the VAV Zone
Controller before or after you wire it for power.
1
If the VAV Zone Controller has been wired for power, pull the screw terminal connector from the controller's
power terminals labeled
Gnd
and
24 Vac
. The controller reads the address each time you apply power to it.
2
Using the rotary switches, set the controller's address. Set the
Tens
(
10's
) switch to the tens digit of the
address, and set the
Ones
(
1's
) switch to the ones digit.
EXAMPLE
If the controller’s address is 25, point the arrow on the
Tens
(
10's
) switch to 2 and the arrow on
the
Ones
(
1's
) switch to 5.
10's
1's
1
3
45
2
7
8
9
6
0
1
3
45
2
7
8
9
6
0
CAUTION
The factory default setting is
00
and must be changed to successfully install your VAV Zone
Controller.
VAV Zone Controllers
13
