Page
10
UNITED EQUIPMENT
SALES CONSULTING CORPORATION
INSTALLATION OF THE REMOTE ALARM/CONTROLLER
1. From the manifold room, run a CAT5 or CAT6 cable from the manifold to the planned location of the
RAC. Allow approximately 12 inches of cable at either end to prevent tension on the connections.
2. The RAC requires a single gang wall mount solution (please follow local code to provide suitable rough-in
box or low voltage trim).
3. Remove RAC from packaging.
4. Loose set screw (do not discard) located at bottom of box and remove front cover. Set cover aside (do
not discard).
5. Plug the cable running from the manifold circuit board into the back of the RAC. Ensure the cable is
“clicked” in and secure. Power up the manifold.
6. Use two screws to secure the alarm to the wall. Be careful not to overtighten.
7. Re-attach the front cover to the RAC and tighten set screw.
8. Test both function and display by proceeding with the same test procedures as the manifold (ex. Stand-
By and Mute). Test to make sure all LED's are lighting in accordance with the manifold status.
INSTALLATION
INSTRUCTIONS
