Page 5 of 6
RECOMMENDATION & SAFETY REQUIREMENTS
Other documents, which may be appropriate for your applications, are available on request.
CODE
IDENTITY
DESCRIPTION
X10255
SRA
Safety requirements: Addressing the Low Voltage Directive (LVD) including,
Thermal data/cooling, Live parts warning Earth requirements and Fusing
recommendations.
P01.1
COS
UAL Conditions of sale.
NOTE:
It is recommended that installation and maintenance of this equipment should be carried out by suitably
qualified personnel, with reference to the current edition of the I.E.E. Wiring Regulations BS7671. The
regulations contain important requirements regarding the safety of electrical equipment.
Not for general waste
ADDITIONAL INFORMATION
When using a remote switch it is important that an additional cable gland (not supplied) is used to
ensure the IP rating is maintained.
The rear of the enclosure contains the PCB; this will need to be removed before attempting to fit the
additional cable gland. Remove the four fixing screws and remove the PCB. The ‘knock-out’ can then
be removed and the additional gland fitted as shown above. This should be done very carefully -
ensure the gland is tightened up using a spanner. Refit the PCB and secure with the screws.
Remove the link that is fitted into the INPUT/COM terminals and wire in the switch wires.
Once the additional gland has been fitted the units should be mounted as shown above.
This is the only time the unit should be mounted in this way. If the additional switch is not being used
then the unit must be fitted with the gland facing down. Once the unit is wired, the lid should be refitted
as shown.
CE MARKING
This product family carries a “CE” marking. For more information see RECOMMENDATIONS section
and contact our sales desk. A Declaration of Conformity is available on request.
