@
+91 7046223333 , 9427301436
www.utplindia.in
www
2
1.
Instructions
1
Function
1. OVERVIEW
1.2 Safety Notes
Please read this manual carefully and completely before you use the device for the first time. The device may only
be used by qualified personnel and repaired by UNITECH Instruments personnel. There is no warranty of damages
or injuries caused by non-observance of the manual.
The device may only be used in approved temperature range.
Ø
The opening of the case should only be done by qualified personnel.
Ø
The instrument should never be placed in the highly power noise environment.
Ø
You should not make any technical changes on the device
Ø
The appliance should only be cleaned with a clean damp cloth OR use only pH-neutral cleaner.
Ø
1. Check if the package well when recived the goods. Conform the model number and Parameter.
UT-9003
PRESSURE TRANSMITTER
2. When install the transmitter, tighten the transmitter with a wrench from the bottom nut of transmitter .
(When Installation wiring Should be in the OFF state, avoid rotating the upper part of the transmitter directly)
3. The Transmitter is used for the medium that can not corrosive on silicon and Stainless stell (or aluminum).
4. The max pressure of the measured system can not exceed 150% FS of rated pressure.
5. Please Don’t put the sharp and hard things into the pressure input hole, in order to prevent the chip damage.
7. Please read notes before using, or else it is the user’s responsibility.
6. The end lead wire of sensor can not lead into the water to prvent conduction.
Содержание UT-9003
Страница 6: ......
