6
Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Installing the Battery
WARNING!
There is a risk of fire and burns if the battery pack is handled
improperly. DO NOT disassemble, crush, puncture, short external
contacts, or dispose the battery pack in fire or water. DO NOT
attempt to open or service the battery pack. Dispose of used
batteries according to local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss when
the main battery pack is removed or completely discharged. This backup
battery will keep the data and system setting for up to 2 hours if the main
battery is removed.
NOTE:
To enable the backup battery cell to provide backup power supply,
charge your device with the main battery pack for at least 16 hours.
NOTE:
To power on the device properly, make sure to replace the battery
compartment cover after installing the battery.
1. Open the battery compartment
cover by sliding the tabs on both
sides in the direction of the arrows
shown and lift the cover up.
2. Push up the backup battery switch
to the “ON position by using a
stylus to turn on the backup
battery.
3. Slide and position the battery
pack, making sure the battery
contacts are aligned with the
contacts in the compartment.
4. Use your thumb to snap the
battery down for it to be in place.
Battery Compartment Tab
Backup Battery
Switch
Battery
Compartment
Contacts
Plastic Tab
