MSR120 Programmer’s Manual UDN PM010, Rev. 1.1
Appendix A -- USB Driver Installation 2003/1/21
Appendix A USB Driver Installation
This section illustrates instructions in
the USB driver installation guide for Windows 95/98
.
!"
System Requirements
Before you use the MSR120, make sure your computer is an IBM PC-compatible with the following minimum
system requirements:
1. Intel-compatible 486DX-66 MHz CPU or higher
2. One standard USB port (4-pin) and has the symbol
3. Either the following operating systems:
Windows 95 OSR2.1 (B version) with USB version 1214, Windows 98, Windows 98 SE, or Windows 2000.
!"
Driver Installation
Follow the steps below on installing the MSR120 for the first time:
1. Power on computer where you will connect the MSR120 and make sure that the USB port is enabled and
working properly.
2.
Plug in the USB cable into the USB port and Windows will detect an USB Device and run the
Add New
Hardware Wizard
to assist you in setting up the new USB Composite Device.
3. Insert the USB driver diskette (DISK 2) into the floppy drive and click
Next
to continue:
a. Select
Search for the best driver for your device
and click
Next
.
Page A-1
Proprietary and Confidential
Total 36 pages
