Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
20
Chapter 3
Operation
Overview
The HT630 has several operating modes to optimize performance for various
purposes. The diagram below shows the operating flow of the HT630 and summarizes
how to switch between different modes.
System configurations are categorized in two groups. Users can select the “8.SET”
command in User Mode to set general system configurations or enter Supervisor
Mode to set advanced system configurations. The Supervisor Mode is password
protected to prevent unauthorized personnel from changing system configurations.
The default password for Supervisor Mode is “630”.
It is likely that your HT630 came configured by your software vendor or system
developer. If this is the case, please use caution when changing these settings.
Press and hold down
enter
‘Program
Name’
then press
OFF
APPLICATION
mode
USER
mode
SUPERVISOR
mode
then press
press
press
press
press
press
RUN
command
(for two
seconds)
and
keys
1.RUN 2.TER
3.COM 4.DIR
5.ERA 6.TYP
7.CPY 8.SET
HT630 V1.00
MEM 512KB
>
<<START MENU>>
1.SUPERVISOR
2.WARM START
3.COLD START
