Unitech Hand Held Scanner, Руководство пользователя

Страница: 16 / 56

Page 15
Chapter 6 Setup
The scanner interface can be configured to fit the user's specific
application. All configuration parameters are stored in a non-volatile
memory, which is retained even if power is lost.
6.1 Bar Code Menu Setup
The setup menu in
Appendix D contains eight groups:
* Group 1: Device selection.
* Group 2: Beep and delay.
* Group 3: Keyboard and Wand Emulation.
* Group 4: RS-232 Settings
* Group 5: Scanner port.
* Group 7: Code 39, I 2 of 5, S 2 of 5 and Code 32.
* Group 8: Code 128, Code 93, Code 11, Codabar, and MSI.
* Group 9: UPC/EAN, and Delta Distance Code.
* Group 10: Data Editing.
* Group 11: Dump setup.
6.1.1 Setup Procedures:
For most parameters, proceed the following steps for the setting:
1) Locate a group that contains the parameter to be changed.
2)
Scan the " Enter Group # " label to enter setup mode. The green
LED on the scanner will flash to indicate that setup is in progress.
3)
Scan the label ( on right hand side ) representing the parameter to be
changed.(For example, B1 label)
4)
Scan the labels ( number ) representing the desired parameter value.
(For example, 05, scan “ 0 ” and “ 5 ” labels.)
5)
Repeat step 3 and 4, if necessary, to change the parameters in the
same group.
6)
Scan " Exit " label to end the group setup. The scanner will make
two beeps to end the setup.