To ensure the unit working properly, please keep all
connectors away from the contaminants staying
inside of them such as dust, grease, mud, and water.
The negligence may cause the unit with no
communication, short circuited, Overheated and
so on. If the connector is damaged, please ensure
the connector is being fully repaired before using
the unit to avoid causing short circuited.
Install the Battery Cover
Checking LED Status
Charging the battery
Remove Battery Cover to Install Battery
Insert the battery cover in the direction as shown in the
picture below:
Remove the battery cover in the direction as shown in the
picture below:
Before using the terminal for the first time, you need to
charge it for about 24 hours. For the regular use, you
can charge the terminal for 4 hours to recharge the
battery to full capacity.
To charge the terminal, please use the USB charging cable
or the cradle.
Turn the latch to the left to unlock
the battery cover.
Lift the battery cover up to 45 degrees (45
°
) angle
by pulling the bottom-left corner up then gently take
the cover off.
1
2
There are three hooks on the battery cover. Align
the hooks with the recesses on the battery
compartment.
Insert the battery cover up to 45 degrees (45
°
) angle,
from top to bottom.
Align the battery cover with the recesses of the
battery compartment and press the battery cover
down to secure in place. Make sure there is no gap
between the device and the battery cover.
Lock the battery cover by turning the latch to the
right . Make sure the battery cover is securely closed,
or you may not be able to turn on the terminal.
1
2
3
4
WARNING!
There is a risk of fire and burns if the battery is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts, or
dispose the battery pack in fire or water.
DO NOT attempt to open or service the battery. Dispose of used
batteries according to local recycling guidelines in your area.
CAUTION!
http://www.ute.com/
Copyright 2021 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
LED
Description
Red Light
．
Battery Charging
．
Twinkling to indicate battery low
status(less than 15%)
Green Light
．
Battery Fully charged
．
Barcode scan good read
Blue Light
．
Message
If scanner app is running, LED is controlled by scanner
app. No LED (Red and Green) display when battery is
out. (even AC IN)
Pull the plastic sheet and remove the battery from the top.
Connect the type C USB cable to the USB port on EA520
and the other end of the USB cable connect to AC power
adapter into the electrical outlet on the USB plug.
The charging LED indicator on EA520 is turning red when
it is in charging state.
Align the battery with the bottom slot in the battery
compartment
3
Press down the battery and secure in place.
4
Remove the battery
