Unit UCM-870, Инструкция по эксплуатации

Страница: 5 / 19

Be sure to use a quality grinder or mill for uniform consistency in your espresso grind. Oval shaped
coffee mills are not recommended because the grind is not consistent.
Before Using Your Espresso Maker
1. Wash the all the accessories including the Removable Water Reservoir (5), Frother (7), Drip Tray
Cover (8), Drip Tray (9), Filter Holder (15), Cups (16), and Measuring Scoop (18) in a mixture of
mild detergent and water. Rinse each thoroughly.
2. To rinse the inside of the machine, follow steps for brewing espresso using water only.
3. Unwind the Power Cord (20) of your machine.
How to make an Espresso
1. Fill the Removable Water Reservoir (5) to the MAX (80% of Reservoir) but not less than the MIN
level.
2. Remove the Filter Holder (15) and add the ground espresso coffee beans to the Metal Filter Basket
(10). If the Metal Filter Basket (10) has been removed from the Filter Holder (15), ensure it is
replaced before adding ground espresso coffee beans.
Note: If you want your coffee with cr
é
me, place the Creme Processor DuoCream (14) under the Metal
Filter Basket (10).
3. Fill as desired by locating the graduation marks “1” and “2” on the Metal Filter Basket (10). The
numbers indicate the number of cups of espresso that can be produced. Press the coffee evenly
down with the back of the Measuring Scoop (18).
Note: Ensure that the Steam Control Knob (2) on the right of the Espresso/Cappuccino Machine turn
to the Indicator position OFF .
4. Place the Filter Holder (15) underneath the Adaptor (19) so that the Handle (13) is positioned to the
left of center. Lift the Filter Holder (15) is secure.
5. Plug the Espresso/Cappuccino Machine into a standard domestic power outlet and turn the Switch
Control Knob (3) to the indicator position .
6. The Espresso/Cappuccino Machine is ready for use when the pre-heat indicator light that flashes
in red light turns into stable red light without flashing.
7. Position the espresso Cups (16) under the Adaptor (19). Place both of the Cups (16) under the
Adaptor (19) with one nozzle over each cup.
8. Turn the Switch Control Knob (3) to the coffee indicator position . After a few seconds, espresso
will start to dispense from the nozzle into the Cups (16).
9. When sufficient espresso has been made, turn the Switch Control Knob (3) to the indicator
position .
Note: There may be slight dripping from the nozzles after the Espresso/Cappuccino Machine stops
due to excess water in the espresso Filter Holder (15). The Drip Tray (9) is designed to collect this
liquid.
10. It is now important to release the steam pressure by following the directions under
“Pressure” .
Note: Never remove the espresso Filter Holder (15) until all steam and hot water has been
released.
HOW TO MAKE CAPPUCCINO
1. Cappuccino is espresso topped with steamed and frothed milk. Frothing milk for cappuccino takes
practice. Do not discouraged if it is not perfect the first time. It may take a few times before you
perfect this process.
2. For best results, we recommend frothing the milk in a separate pitcher and pouring the milk into
your coffee. The milk and pitcher should be cold. Do not use a pitcher which has just been washed
in warm water.
Make the espresso as described previously. When finished making the espresso, proceed as follows:
1. Ensure the Espresso/Cappuccino Machine is switched off and the Steam Arm (6) is rotated
outwards to the right.
2. Fill the stainless steel jug approximately half full of milk.
3. Turn the Switch Control Knob (3) to the indicator position .
ENGLISH
5