UNIS WORK ZONE, Руководство по эксплуатации

Страница: 22 / 27

Work Zone GMP Manual
08/25/2022
21
If you see following error signs showing on the Setting panel, please try the recommended
action.
Display Possible Cause Recommended action
Do not shake the machine
Shake the machine or tilts the
machine.
Do not shake the machine.
The anti-shake alarm device is
stuck.
Please take away the gift
Prize optical sensor recognition is
abnormal.
Take out the
prize
.
Optical sensor cloth should be
pasted flat on the front.
The Optical sensor
is faulty. Replace
Optical sensor
.
Coin slot error
The coin mechanism signal is
faulty.
Turn the NO/NC switch to the
NO position.
The coin mechanism
is faulty. Replace
coin mechanism
.
Crane sensor malfunction
The crane do not touch the
front limited sensor.
Restart the machine.
Connector became loose
during transport.
Check and reconnect the
front limited sensor and
Front&back motor connector.
Front limited sensor is faulty. Replace Front limited sensor.
Front&back motor is faulty. Replace Front&back motor.
Crane sensors stop failure
The crane do not touch the
Back limited sensor.
Restart the machine.
Connector became loose
during transport.
Check and reconnect the
Back limited sensor and
Front&back motor connector.
Back limited sensor is faulty. Replace Back limited sensor.
Front&back motor is faulty. Replace Front&back motor.
Crane left stop failure
The crane do not touch the
Left limited sensor.
Restart the machine.
Connector became loose
during transport.
Check and reconnect the Left
limited sensor and L&R
motor connector.
Left limited sensor is faulty. Replace Left limited sensor.
L&R motor is faulty. Replace L&R motor.
Claw rising fault
The claw do not touch the
Rising limited sensor.
Restart the machine.
Connector became loose
during transport.
Check and reconnect the
Rising limited sensor and
Rising motor connector.