8
MAINTENANCE
TO REMOVE LINT FILTER:
Gently press downward and pull the lint
filter holder from the filter frame
TO REPLACE LINT FILTER:
Insert bottom tab of lint filter holder into
the bottom of the filter frame and gently
push the filter holder back into place.
CLEANING THE FILTER
There will be lint left behind in the overflow
filter and in the lint filter after each wash cycle.
These filters need to be cleaned after every
load in order to maintain correct operation of
the washing machine and to ensure that the
drainage pump does not become clogged.
• The lint filters must be in place during each
wash cycle.
• Slide the lint trap down until it rests below
the surface of the water (the lint trap will not
work correctly unless it is fully submerged.)
• The lint filters must be cleaned after each
wash cycle.
Over
flow
drain
Wash water
level slider
for lint trap
Removeable
lint trap
REMOVING THE LINT FILTER
• After the wash is complete, hold the filter
frame, gently press downward and pull the
lint filter/holder from the filter frame.
• Rinse filter clean under running water and replace it by inserting
the bottom part of the filter frame into the slot and gently pushing
the filter back into place.
• After all washing is complete, remove the filter as described above,
rinse the filter clean under running water and allow it to dry away
from direct sunlight and heat sources.
• Once the filter is dry, place it back into the filter holder.
IMPORTANT: Always unplug the power supply cord
before moving the washing machine or performing any
maintenance.