Unique UGP 13, Руководство пользователя

Страница: 18 / 36

U G P 1 3
13
o
Before removing burner orifice, clean burner area of any soot, scale or
dirt. Remove the orifice and soak it in alcohol (isopropyl alcohol or
thinners) and blow it out with compressed air. Re-install and tighten
burner orifice.
o
Replace burner
Warning - DO NOT use a pin or wire when
cleaning the burner orifice as damage can occur to
the precision opening. This can cause damage to the
refrigerator or create a fire hazard. It will also create
extremely dangerous levels of carbon monoxide.
o
Replace components in reverse order
o
Be sure to reconnect the wire to the electrode. Check the electrode for
proper location and gap.
See figure #8
o
The inlet & outlet gas fittings on the refrigerator need to be checked
for leaks. Apply a noncorrosive bubble solution to the fittings and
observe for leaks. The safety valve will not allow gas pressure to any
connections between it and the burner orifice. These fittings must be
checked while burner is in operation (gas flow will be present between
safety valve and burner head)
W
ARNING
–
The safety shut-off (“C” button
Fig#4) must be manually depressed to allow gas
pressure to flow to the burner orifice. Be sure to
apply the leak check solution before depressing
the safety shut–off. DO NOT allow any open
flame, sparks, smoking, etc. in the area of the test. DO NOT depress
safety shut-off for over 30 seconds.
o
If a leak occurs, correct problem, recheck with leak test solution then
light the burner according to the instructions under
G
ENERAL
O
PERATING
I
NSTRUCTIONS
– G
AS OPERATION
,
C
HAPTER
3
Fig# 8