COPYRIGHT 2016, UNIQUE AUTOMATION
- 8 -
08/11/2016 12:57
Main menu
Access the main menu by press the menu button
From within the main menu using
/
buttons select the option you wish to
change then use / to make the required change. Confirm the choice with
Main menu options:
CHILD LOCK
Cleaning or child lock. To unlock the keypad press and
hold until the display lights up.
SET TEMP C/F
Set temperature units Centigrade or Fahrenheit
ECO
After a preset has been used, when enabled the true
bath depth before draining replaces the prese
t’s depth.
You need to leave the bath and allow few seconds prior
to draining
Eco or Auto Learning enables bathomatic to follow your
preferences and/or wait and draw the perfect bath every
time without wasting water or energy for heating it
SET SLEEP TIME
1 or 5 minutes
AUTO PAUSE
Allows auto-pause when there is not enough hot water
T TO DEPTH WARNING
Depth to T° warning. When this function is ON and the
device’s T° to depth calibration in the Service Menu has
been set a warning message will appear. When this
function is set to OFF there will be no message, but
there will be no guarantee of perfect water depth and
temperature delivery
TEMPERATURE PRIMING
With this function ON bathomatic runs water in the bath
at maximum temperature with open drain. When the
water temperature running by the temperature sensor
reaches the desired temperature the drain closes and
normal filling proceeds. This function should be enabled
only when low bath depth are needed.
To minimise the environmental impact on the
“
TEMPERATURE PRIMING
” function it is recommended “
T
TO DEPTH CALIBRATION
”
is carried out
SETUP MENU
CALIBRATION
DEPTH CALIBRATION
SET LEVEL
– Allows for XXX% desired depth
SET 0%
– Saves 0%
SET 100%
– Saves 0%
TEMP CALIBRATION
TEMPERATURE OFFSET
T TO DEPTH CALIBRATION
