UniqAir Uniq, Руководство пользователя

Страница: 23 / 24

U n i q A i r | 21
3. Using a cross-head screwdriver, turn the rear cover quick-release
screws (4 screws) 90 degrees counterclockwise, until the screws
pop out.
4. After loosening all four quick-release screws, lift the back cover
vertically upwards. NOTE! The quick-release screws should remain
in the holes in the back cover.
5. Remove the EPP disc from on top of the filter and lift the filter out
of the air purifier.
6. If necessary, replace or wash the pre-filter fitted around the outer
circumference of the main filter.
7. Fit the newly cleaned pre-filter around the outer circumference of
the new main filter, and place the filter assembly perpendicularly
back into the air purifier.
8. Place the EPP disc on top of the filter assembly with the convex
side facing out.
9. Replace the back cover by aligning the screws on the four brackets,
keeping the logo at the top and fitting the semi-circular opening on
the edge of the cover against the stand.
NOTE! The edge of the back cover should fit inside the perforated band
around the perimeter of the air purifier. The easiest way to do this is to
place the top edge (logo side) of the back cover inside the perforated
band first, and then the bottom edge.
10.
Lock the screws into their brackets by pressing them with your
finger or lightly with a screwdriver, for example. NOTE! There is no
need to turn the screws.
11. Lift the air purifier back into place and plug in the power cord. The
device will be operational again.