5
2. Camera Setup
A basic camera and frame grabber system setup, as shown in Figure 1 below, requires a UC-600 camera, a
standard C-mount lens, a PS-12C power supply or equivalent, a PC system and a VGA monitor, a frame grabber,
and an external trigger device if necessary.
Figure 1 Camera and Frame Grabber System Setup
3. Camera Functions
3.1 12-Pin Connector
The 12-pin Hirose connector is located on the rear
panel of the camera. All ground signals on pin 1, 3,
5, and are common grounds. Al12 V DC
input is recommended for pin 2, this camera should
wit12 V
±
1V input voltage. Make sure to
set the NM/AM switch to NM position for external HD
and VD locking. For HD (pin 6) and VD (pin 7)
inputs, TTL signals are required (see section 5.9 for
details). All pin 9, 10, and 12 are not connected
(N/C) or reserved for special options.
For asynchronous capture (VINT) applications, refer
to section 5 for details. Figure 2 below shows a top
view of the 12-pin Hirose connector.
Pin No.
Description
1
GND
2
+12V DC input
3
GND
4
Video
5
GND
6
External HD
7
External VD/VINT
8
GND
9
N/C
10
N/C
11
Integration control
12
N/C
Figure 2 12-Pin Hirose Connector
