Unipulse TM700, Руководство по эксплуатации

Страница: 44 / 91

35
5 SETTING OF FUNCTIONS
35
SE
TT
IN
G
O
F
FU
N
C
TI
O
N
S
Chapter
5
However, when the auto reset functions, if the signal causes chattering, the point that should be
taken originally may deviate. Switching is provided so as to prevent the next detection from being
performed until the T/H signal is turned on even if the SECTION signal is turned on again.
≪
Setting value
≫
ON, OFF
How to set
OFF: After a hold is decided, the next detection is not started until the T/H signal is turned
on even if the SECTION signal is turned on.
ON: After a hold is decided, the next detection is started when the SECTION signal is
turned on again even if the T/H signal is not turned on. This is the initial setting
(factory default setting).
■
Renew of hold value
You can change the operation of renewing the hold value display.
≪
Setting value
≫
All time, Detect end
How to set
All time: When detection starts, the previous hold value is canceled and the indicated
value is displayed by tracking. When the hold condition is met, the indicated
value is held.
Detect end: When detection starts, the previous hold value is maintained, and no tracking
state is displayed. If the hold condition is met when the hold section ends, the
hold value is renewed. This is, however, effective only when hold auto reset is
ON.
SET. Hold Setting Page 1
→ →
Meas. Setting
→
When auto reset is on in externally specified section
SECTION
H/E
T/H
When auto reset is off in externally specified section
SECTION
H/E
T/H
SECTION
H/E
T/H
SECTION
H/E
T/H
When auto reset is on in externally specified section peak hold
When auto reset is off in externally specified section peak hold
The first hold value is maintained
until T/H is inputted.
The first hold value is maintained
until T/H is inputted.
If the SECTION signalchatters,
the point shifts from the proper
one.
If the SECTION signalchatters,
the point shifts from the proper
one.
sample hold
sample hold
SET. Hold Setting Page 1
→ →
Meas. Setting
→