Unipulse TM201, Руководство по эксплуатации

Страница: 35 / 58

26
4 Calibration
26
Calibrat
ion
Chapter
4
4-2.
Sensor type setting and calibration
„
Standard
Select the type of UTM Ⅱ connected.
„
Custom
Select UTM
Ⅱ
/UTM and input the rated capacity.
The rated capacity unit is Nm.
If using UTM
Ⅱ
not in the standard list, select custom.
„
Calibration
By setting the sensor type or clicking the "Calibration"
button, the following dialog is displayed. Click "OK" to
start calibration.
Once the calibration starts, display conditions of torque,
rotation speed and power can be selected in order.
Selection screens are displayed in the following order.
Select the appropriate condition respectively and click
"OK".
Click "Return" to go back to the previous selection screen and "Cancel" to stop the calibration.
Setting cannot be changed once canceled.
When the calibration setting protection is ON, calibration cannot be performed.
Follow (1) and (7) of P.29 "4-3.Procedures of equivalent input calibration and
actual load calibration (torque)" to change the setting.
Key points