Unipulse F160, Руководство по эксплуатации

Страница: 51 / 99

42
5 FUNCTIONS
42
FUNCTIONS
Chapter
5
■
Sequence without Judgment
●
Over/Under judgment is not made when the setting of the number of judging times of setting
code 15 is 00.
●
The complete signal is output at the OFF edge (ON
→
OFF) of the final (SP3) signal deregarding
the setting of the complete output mode of setting code 26.
t1: Comparison inhibit time; comparison inhibit time of setting code 10
t3: Complete output time; complete output time of setting code 12
t4: Adjust feeding time; adjust feeding time of setting code 13
■ About the Stop Signal (Setting Code 84,85)
●
When the stop signal turns ON during weight cycle, a sequence error 2 will result and all the
signals of SP1, SP2 and SP3 are turned OFF.
●
If the start signal is turned ON when the stop signal is ON, it will become a sequence error 1 and
will not start the weighing.
●
To reset the sequence error, input the stop signal or the sequence error reset signal again.
* Sequence start and sequence stop can also be executed by setting code 84 (start) and setting code
85 (stop), respectively. For the setting method, refer to "Example 3) Setting method
①
for
command execution" on page 15.
Start
Stop
SP1
SP2
SP3
ON
ON
ON
ON
OFF
t1
Complete
Comparison inhibit time
Complete output time
t1 t3
ON
Start
Stop
SP1
SP2
SP3
ON
ON
ON
ON
OFF
Sequence error
ON
Err2
ON
ON
Err1