Unipulse F160, Руководство по эксплуатации

Страница: 24 / 99

15
3 SETTING PROCEDURE
15
SET
TING PROCEDURE
Chapter
3
Example 3) Setting method
①
for command execution
As for operational commands (setting codes from 80 to 86) in "9-1.Setting Code List" on page 78,
operation is executed when each setting is changed from "0" to "1."
Executing Digital Zero (setting code 82)
1.
From the indicated value display screen,
set setting mode 8 by pressing
[FNC] → [ ][ ][ ][ ][ ][ ][ ][ ].
2.
Select item number 2 with [
△
]/[
▽
].
The item number and "0" are displayed.
3.
Make "0" flash with [ ].
Set "1" with [ △ ]/[ ▽ ].
4.
Determine it with [ ], so that digital zero is executed.
* To cancel the execution, set "0" or press [FNC] to go
back to the set value display ("0" display).
Example 4) Setting method
②
for command execution
As for operational commands (setting codes 91 and 92) in "9-1.Setting Code List" on page 78,
operation is executed when a set value is input and then determined.
Executing Actual Load Calibration (with Balance Weight set at 25000)
1.
From the indicated value display screen,
set setting mode 9 by pressing
[FNC] → [ ][ ][ ][ ][ ][ ][ ][ ][ ].
2.
Select item number 1 with [
△
]/[
▽
].
The item number and set value are displayed.
3.
Enable change with [ ], so that the most significant
digit of the set value flashes.
Move one digit with [ ], so that the second digit
(thousands place) from the most significant digit
flashes.
Set "5" with [ △ ]/[ ▽ ].
4.
Determine it with [ ], so that actual load calibration is
executed.After execution, you will go back to the gross
weight display.
* To cancel the execution, press [FNC] to go back to the
set value display.
▽ ▽ ▽ ▽ ▽ ▽ ▽ ▽
▽ ▽ ▽ ▽ ▽ ▽ ▽ ▽ ▽
▽