Unipro UniTire, Руководство пользователя

Страница: 24 / 28

24
Battery change
To replace empty batteries
When it is time to change the batteries a small
battery symbol is shown in the bottom of the
display. This does not mean that UniTire will
stop functioning. The battery symbol is shown
when the battery voltage is around 2.2V. Five
different steps is shown all the way down to
1.7V.
The battery voltage is measured continuous
when UniTire is turned on.
The batteries are located inside the box. Put
UniTire on the table with the rear side up.
Unscrew the two screws and remove the rear
part of the box by lifting the end with the two
screws. Here you will see a battery holder with
two standard Alkaline 1.5V AAA batteries.
Please replace them with two new ones of high
quality. Be careful to put them in with the right
polarity. If you should by accident put them in
the opposite direction, you will not hurt UniTire
or the batteries.
When assembling UniTire again, slide the rear
part into the front part and center it before
closing it. Please do not over tighten the two
screws!
Please do not dispose the batteries in the na-
ture. Use the official return channels for them!
Cleaning
To clean the case, display, and buttons
The exterior surfaces of UniTire products are
made from solid anodised aluminium, plastic
overlay, and stainless steel.
They are designed to be easily wiped clean
with a dry, lint free cloth. Greasy marks should
be removed by light rubbing with a slightly
damp cloth and a trace of proprietary glass
cleaner. Do not use any other solvent or abra-
sive based cleaners.
Ensure that no liquid enters the box and that
the product is completely dry before reuse.
Maintenance
T r o u b l e -
s h o o t i n g