- 2 -
PoE Status
The PoE Switch is with the function of the LCD display and PoE. The LCD can display the working condition of PoE port not
only, still can accurately show the state of each port, such as: Output power, Overload, Short circuit, Light load, Low voltage,
Over voltage,High temperature, and so on...
DIP Switch
The DIP switch located on the left panel.
Standard:
the factory default mode, can normal communication between port 1~10.
VLAN:
1-8 port can be isolated each other but 1-8 port can connect to 9/10 port after open VLAN to stop broadcast storm
to increase forwarding rate of frame.
Extend:
Up to 250m PoE distance allows you to expand you network via Ethernet cable to where there is no power line or
outlet but where you want to fix device such as IP Cameras.
LED indicator
LED
Color
Function
PWR
Green
Off: No Power supply.
Light: Indicates the switch has power.
LNK/ACT
Red
Off: No device is connected to the corresponding port.
Light: Indicates the link through that port is successfully
established at 10/100Mbps.
Blink: Indicates that the Switch is actively sending or
receiving data over that port.
Green
Off: No device is connected to the corresponding port.
Light: Indicates the link through that port is successfully
established at 1000Mbps.
Blink: Indicates that the Switch is actively sending or
receiving data over that port.
PoE
Orange
Off: No PoE powered device (PD) connected.
Light: There is a PoE PD connected to be port, which
supply power successfully.
Blink: Indicates port abnormal power supply.
