FOR WARRANTY INFORMATION VISIT
UNIOS.COM/WARRANTY
Please read these installation instructions carefully before installing this luminaire. The luminaire is designed for installation in accordance with relevant
Australian Standards (AS/NSZ 3000). Installation of this luminaire must comply with local and national regulations. If luminaire is not installed
according to the instructions, the warranty for the luminaire may be void.
ENQUIRIES
+61 8 9248 1888
Edition 10.11.17 |
Product design and technical data may be subject to change
1
2
Mark out orientation of Aeon Flex.
If shortening is required, ensure set cut
lengths are followed. Refer to cut marks
on product for cut lengths. If cut, please
use additional end caps to reseal profile.
Install supplied mounting clips in
suitable locations.
Note: Locations will differ depending on
the shape. It is recommended to install
clips at the curvatures of the flex.
3
4
Install Aeon Flex onto
mounting clips.
Ensure mounting clips are clipped
correctly onto the grooves of the Aeon
Flex to prevent the luminaire from
moving during operation.
Plug Aeon Flex into suitable
24V DC electronic control gear.
Refer to power supply requirements.
Termination of wiring and installation of
the product shall be conducted such
that the luminaire’s stated IP rating is
not affected.
1
2
3
4
50mm
50mm
50mm
50mm
unios.com
Page
2/2
Cutting Aeon Flex
Cuts can be made at every 50mm for standard CCT or 100mm for
RGB. Cut marks have been printed on the bottom side of the flex for
easy marking.
When cutting Aeon Flex to size, ensure that the cut is made in one
steady motion at a 90° angle to the strip. This will provide a clean
surface for the end cap to slide onto and secure to.
Once the cut has been made, place a small amount of adhesive in
the end cap and slide the endcap onto the flex, ensuring a complete
seal to maintain its IP rating. Follow the instructions of the adhesive
to provide enough time for the adhesive to dry and hold the endcap
to the flex.
For more information on cutting Aeon Flex visit unios.com/aeonflex
Mark out orientation of Aeon Flex
and install mounting clips in
suitable location.
It is recommended that there is a
mounting clip installed every 500mm.
Install extrusion onto
mounting clips.
Ensure mounting brackets are clipped
correctly onto the grooves of the
extrusion to prevent it from moving
during operation.
Install Aeon Flex
onto extrusion.
Ensure Aeon Flex secured tightly onto
extrusion to prevent it from moving
during operation.
Plug Aeon Flex into
a suitable 24V DC driver.
Refer to power supply requirements
above. Termination of wiring and
installation of the product shall be
conducted such that the luminaire’s
stated IP rating is not affected.
Installation with Mounting Clips
Please read instruction manual on
both
sides carefully before bending product.
Extrusion supplied separately.
Installation with Extrusion
