WWW.UNILITE.CO.UK
3
OPERATION
Battery Display
Run Time Count Down
Setting
Button
Run Time Setting Decrease
Main Lamp Button
Trigger
Switch
Run Time
Setting
Increase
Ultrasonic Range Finder Distance
General Operation
- Put the UV protection glasses on and do not
remove them while the UV light is being emitted.
- Press the button for more than 1 second to
Power on or off. Then pull the trigger to switch
the UV light on or off.
Locking Protection System
- Double click to lock or unlock the lamp when
the power and display screen is off.
Setting Procedure
- Press button once to start the ‘minutes’ setting
mode, the minutes display will keep flashing.
Press or button to adjust the minutes
required (max 10).
- Press button again to enter the ‘seconds’
setting mode, seconds display keep flashing.
Press or button to adjust the seconds
required (max 60).
- Press and hold or buttons to adjust faster.
The maximum time can be set to "10:00" minutes.
- Press button for 5 seconds to confirm the setting
chosen.
- The countdown will start after the trigger has been
pressed.
- The countdown can be paused when the trigger
is pressed once. It will continue after the trigger is
pressed again.
- When the lamp is switched off the next time
it is switched back on it will remember the last
countdown setting used.
- The UV light will automatically switch off when the
remaining time on the display shows " ".
- The lamp will automatically power off after 60
minutes of no operation.
UV-CURE
CURING LAMP
/ 395nm
