08
21 If you wish to install LEDs, insert each
individual LED into the Cherry MX
switch’s LED socket and solder them
one by one, make sure to do them one
by one so that each LED is deeply
seated and does not poke out and
obstruct the keycaps.
Make sure the long lead
goes to the circular pin
and the short lead goes
to the square pin
22 Cut off the leads with a nail clipper
or snipper
21 (Optional) cover the surface of the
controller with some black tape
22 Prepare for the next step by obtaining
and orienting these two pieces of
acrylic as follows
23 Stack the plates in the order as shown below and screw the screws
marked red below
Bottom
Top
Screw this screw in
