Unika PA-664, Инструкция пользователя

Страница: 4 / 12

FRONT PANEL
1. Rack Mounting Ears - Two front panel mounting holes are provided on
each mounting ear.
2. Rack Handle - PA Series amplifiers are designed with rack handle at
two each side. It's not only to make the entire design elegant but more
practical and convenient for users.
3. Fan Inlet Grills and Filter - PA Series amplifiers are cooled by two rear
mounted fans. Cool air from front grills is filtered and flows over the
heatsinks and exhausts to back side.
Make sure these outlets remain clear to allow unrestricted air flow.
4. AC Power Switch - PA Series amplifiers have a front-panel AC mains
power switch.
5. Power Indicator - This LED will glow when mains power is applied to
the unit. This light may continue to glow briefly after mains power has
been turned off, this is normal.
6. Channel 1-4 Signal Indicator - This LED indicates that a signal (above
a minimum threshold) is present at the amplifier input, and that the
signal is being amplified.
7. Channel 1-4 Clip Indicator - This LED will begin to flash when the
channel begins to overload (clip), at this point the channel will begin to
distort. Under heavy clipping activity, lower the channel's gain control to
reduce the risk of damage to your speakers and amplifier. This LED may
glow when the unit has been turned off, this is normal
.
8. Channel 1-4 Gain Control - This rotary knob is used to control the
output signal level of the channel. Turning the knob in clockwise
direction will increase output signal level.
9. UNiKA Logo and Model No - PA Series have 2 types of 2U models PA-
664/PA-1804.
page 3
Figure 1
UNiKA PA-664/PA-1804
Clip Clip Clip Clip
Signal Signal Signal Signal
POWER
CH 1 CH 2 CH 3 CH 4
Min Min Min Min Max Max Max Max
4Ch POWER AMP
PA
UNiK A
1804
1
3
4
2
5 6 7 8 9
Important Precautions Introduction Rear Panel Set Up Operating Modes Protection Specifications
Front Panel