Unika MT-600Q, Инструкция пользователя

Страница: 5 / 12

CH 2 CH 4
CH 1/2
STEREO
BRIDGE
CH 1 CH 3
CH 2 CH 4
BRIDGE
+
_
BRIDGE
+
_
USE ONLY WITH 250V FUSE
_
_
_
_
+
+
+
+
CH 1
CH 3/4
CH 3
BALANCED INPUTS
Ring=(-)
Tip=(+)
Sleeve=Gnd
_ _
+ +
4 Ohms
Minimum
Stereo
Mode
8 Ohms
Minimum
Bridge
Mode
120VAC
60Hz
1200VA
FUSE
T250V
10A L
CAUTION: REPLACE WITH SAME TYPE FUSE AND RATING
ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Designed and
developed
in the USA
Manufactured
in Taiwan
18. Channel 1-4 Input - This is the input terminal of the audio signal
that can be connected to the balanced 1/4” TRS and EuroBlock.
TRS pin setting: Tip/signal positive, Ring/signal negative,
Sleeve/ground.
EuroBlock pin setting: (+): signal positive - Hot, (-): signal negative
– Cold; ( ): ground.
19. Amp. Mode Selection Switch for CH-1/CH-2 - This switch
allows the amplifier operating mode from either stereo or mono
bridge selection. Amplifiers are factory-configured for Stereo
Mode. See section on Mode Selection for more information.
20. Amp. Mode Selection Switch for CH-3/CH-4 - This switch
allows the amplifier operating mode from either stereo or mono
bridge selection. Amplifiers are factory-configured for Stereo
Mode. See section on Mode Selection for more information.
21. AC Power Input - IEC AC power inlet connector, plug this cable
in to a standard 110Vac or 220Vac wall outlet. Be sure that
supplied voltage matches that of the required voltage of your
amplifier. Never plug your amplifier in to a wall outlet that does
not match the required voltage of your amplifier, serious
damage may occur to your unit.
22. Fuse Holder - This holder houses the external fuse. Always
replace with the exact same type fuse, otherwise instructed to
do so by an authorized audio service technician.
23. Fan Outlet Ports - MT series equipped with one single 2-speed
cooling fan. Cooling air enters the amplifier through the front
grills and exhausts through the fan. Be sure not to block these
ports when installing the amplifier or other associated
equipment. Air must flow unimpeded through these ports.
24. Channel 1-4 Output Jack / 5-way Binding Post - Connect to
your speakers input jack. Red is positive signal and Black is
negative signal.
MT-600Q REAR PANEL
page 4
Important Precautions Introduction Front Panel Set Up Operating Modes Protection Specifications
Rear Panel
Figure 2
23 20 18 21 24
UNiKA MT-600Q
19
22