Unika MS550, Инструкция пользователя

Страница: 6 / 16

page 6
Figure 2
1 2 4
5 8 11
ground. The XLR jack is configured as follows; Pin 2 positive, pin 3 negative,
pin one ground. See page 8 for more details on input configuration.
7. Channel 1 Input - Connect the input source for channel one to either the
balance XLR or the balanced/unbalanced 1/4” input jacks. The 1/4” TRS plug
is configured as follows; Tip is positive, Ring is negative and Sleeve is
ground. The XLR jack is configured as follows; Pin 2 positive, pin 3 negative,
pin one ground. See page 8 for more details on input configuration.
.
8. Mono-Bridge / Stereo Selectable Switch - This switch changes the
amplifier operating mode from either stereo or mono bridge. Amplifiers arrive
to you preset in the stereo operation mode.
9. Channel 2 Speaker Output - 5 Way Binding Post - Connect your channel
two speakers to channel two output.
10. Channel 1 Speaker Output - 5 Way Binding Post - Connect your channel
one speakers to channel one output.
11. A/C Power Input - Plug this cable in to a standard 220V wall outlet. Be sure
that supplied voltage matches that of the required voltage of your amplifier.
Never plug your amplifier in to a wall outlet that does not match the required
voltage of your amplifier, serious damage may occur to your unit.
1. THRU - These connectors are parallel c onnected to the Input connectors
and used to connect the input signal to the other power amplifier.
2. Cooling Fan - This is a dual speed cooling fan. This fan is used to cool the
internal parts of the amplifier when in use. Never block the fan in any way
or mount in an enclose rack, doing so may cause the amplifier to overheat
and fail.
3. Output - These are 4 poles SPEAKON type connector for connecting the
power amplifier outputs to the speakers.
4. Circuit Breaker - This breaker is designed to protect the amplifier and your
speakers in the event of an AC overload. In the event of an electrical
overload the breaker will pop-out. To reset the breaker, push it in. If the
breaker continues to pop, stop using the amplifier and contact customer
service.
5. Sensitivity selector - This selector sets the input level for rated power
output
.
6. Channel 2 Input - Connect the input source for channel two to either the
balance XLR or the balanced/unbalanced 1/4” input jacks. The 1/4” TRS
plug is configured as follows; Tip is positive, Ring is negative and Sleeve is
Rear Panel Control
6 7 9 10
3
Introduction Front Panel Set Up Operating Modes Protection Specifications
Rear Panel
UNiK A
6
A
M
P
MS550 / MS750 / MS1050 / MS2050 / MS3050