Unika DI-USB, Руководство пользователя

Страница: 8 / 12

UNiKA DI-USB User Guide
7
Using the headphone output
The Unika DI-USB is also equipped with a stereo headphone output. This
headphone amplifier is controlled by the master output level control, and is
designed to be used to check signal before plugging into a PA system.
Adjusting the level control on the DI-USB will affect both the XLR and the
headphone output. The 3.5mm (1/8") output is designed for both ear buds
and standard TRS stereo headphones where tip-left, ring-right and the
sleeve is ground.
Be careful! The headphone output is set as loud as possible so that it
can be monitored in a live concert environment. If you push the level
too hard it may distort or cause hearing damage!
The UNIKA DI-USB Box is intended for use by professional audio
engineers who are aware of the importance of listening at safe levels.
This same audio level control sets the output going to your PA or recording
system. Once you have determined that the signal from the computer is OK,
reset the level to 7 o'clock. Plug the XLR outputs to your audio system using
standard balanced mic cables. Turn on the audio system, bring up the level
and then turn up the level on the DI-USB Box.
To prevent mishap, always test at a low level.
• 7 o'clock (fully counter-clockwise) - OFF
• 9 to 10 o'clock - MIC LEVEL (Direct box)
• 12 o'clock – Instrument Level
• 5 o'clock (fully clockwise) - LINE LEVEL