UIC680 Programmer’s Manual
UDN PM090-C2 Rev. 2.3
[transfer block]
For option 3 only, the data format is the same as [Block number]. If [transfer block] is not
given, reader will regard it as normal
Decrement
command.
Response ‘^’
-
Acknowledgement
‘*’ - No card response or No power on the antenna
‘!’ - Bad parameter
•
W (57H) – ISO 14443A Detection
COMMENT
Detects ISO 14443A cards.
Response
‘M’ if detects an ISO 14443A card.
•
X (58H) – MIFARE Classic Card Activation(Supports MIFARE Ultralight)
COMMENT Performs
request/anticollision/select command to activate the card.
It is also can be used for any ISO 14443 compatible cards.
Response
ATQA/SAK/serial number if command executed successfully for type A
card
ATQB(12 bytes) if command executed successfully for type B card
‘*’ - No card response or No power on the antenna
•
x (78H) – Card HALT
COMMENT
Card halt command.
Response ‘^’
-
Acknowledgement
‘*’ - No power on the antenna
•
u (75H) – MIFARE Classic Card Read Sector
COMMENT
MIFARE Classic card read sector command.
u[Sector number, 3 bytes]
5-18
