3
OM-SILVER SOAK PRE-WASHING SYSTEM
MAINTENANCE
DANGER: TURN OFF THE POWER TO THE UNIT AT THE MAIN BREAKER PRIOR TO
PERFORMING THE FOLLOWING TASK!
Your Silver Soak Pre-washing System requires minimal routine preventive
maintenance. The following procedures should be done on a routine basis to ensure
that your system remains reliable:
Clean the pump motor fan shroud with a damp, soapy rag. The motor shroud is the
“vented” cover located on the bottom of the motor. This will prevent grease and dust
from accumulating in the cover’s openings, which can obstruct the airflow that cools
the motor.
De-lime the wash tank. Simply add a de-liming agent and warm, fresh water filled to
the water line, and run the system overnight. Ask your chemical sales representative
to recommend a specific de-liming agent.
There are no other preventive maintenance procedures that you will need to perform
on your Silver Soak Pre-washing System. You need not be concerned about greasing
the motor bearings as they are permanently lubricated and sealed. If you have any
questions regarding the preventive maintenance procedures, please contact the
factory at 888-994-7636.
REPLACEMENT PARTS
To order parts, contact your Authorized Service Agent. Supply the model
designation, serial number, part description, part number, quantity, and when
applicable, voltage and phase.
CONTACT US
If you have questions pertaining to the content in this manual, contact Unified
Brands at 888-994-7636.
REPLACING THE WASH WATER
When the water in the pre-washer becomes soil-laden and the detergent is
expired, it must be replaced.
Open the drain valve to release the spent water and detergent.
When all the dirty water has drained out, flush the tank with clean water to remove
any debris that remains.
Remove the drain screen by lifting it straight up and clean it in a scrap sink.
Close the drain valve, replace the drain screen and silverware basket. The pre-
washer is now ready to refill.
