INSTALL MANUAL
IMPORTANT INFORMATION, KEEP FOR OPERATOR
888-994-7636, fax 888-864-7636
unifiedbrands.net
PART NUMBER 36526, REV. B (09/20)
This manual provides information for:
POWER PREP INTRO
THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ,
UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS
CONTAINED IN THIS MANUAL.
NOTIFY CARRIER OF DAMAGE AT ONCE
It is the responsibility of the
consignee to inspect the container upon receipt of same and to determine
the possibility of any damage, including concealed damage. Unified
Brands suggests that if you are suspicious of damage to make a notation
on the delivery receipt. It will be the responsibility of the consignee to file
a claim with the carrier. We recommend that you do so at once.
Manufacture Service/Questions 888-994-7636.
PRE-UNCRATING CHECKLIST
WARNING: DO NOT CONNECT THE MACHINE USING A POWER CORD AND PLUG OR AN
EXTENSION CORD OF ANY KIND.
WARNING: KITCHENS ARE WET ENVIRONMENTS WHICH REQUIRE ALL ELECTRICAL
CONNECTIONS TO BE “LIQUID TIGHT”.
ELECTRICAL INSTALLATION MUST CONFORM TO ALL APPLICABLE LOCAL
WIRING CODES. ALL ELECTRICAL CONNECTIONS MUST BE “LIQUID TIGHT”
AND READILY ACCESSIBLE FOR INSPECTION AFTER INSTALLATION
WITHOUT MOVING THE POWER PREP INTRO MACHINE.
VERIFYING SYSTEM REQUIREMENTS
Prior to completely removing the Power Prep Intro unit from the crate, it is necessary to
verify certain requirements. Remove only the lid of the crate at this time.
Verifying System Direction
The Power Prep Intro can be built as a “Left to Right” or as a “Right to Left” configuration
with a variety of options. Look inside the crate and verify that the configuration of the
machine matches the specifications of the order description.
Verifying the Electrical Requirements
The electrical requirements for the machine are on the machine identification tag
located on the side of the wash tank, next to the motor. The electrical service in the
facility where the machine is to be installed must be rated for the capacity shown on the
identification tag. This machine will require a permanently mounted disconnect that is
in a “liquid tight” enclosure. Do not use an in-line plug for disconnecting the machine
from the electrical source. Contact a licensed and certified electrician for the enclosure
installation using the appropriate breaker (overcurrent protection) and wire size for the
machine’s electrical service.
The information in this document is Confidential and shall not be disclosed to any third party without the express written consent of Unified Brands.
Information contained in this document is known to be current and accurate at the time of printing/creation. Unified Brands recommends referencing
our product line websites, unifiedbrands.net, for the most updated product information and specifications. © 2022 Unified Brands. All Rights Reserved.
