- to prevent fire or
electric shock haz
-
ard, do not expose
this product to rain or
moisture;
- do not overload wall
outlets. Overloaded
wall outlets, loose or
damaged wall out
-
lets, extension cords,
frayed power cords, or
damaged or cracked wire insulation are dangerous. Any of these conditions could result
in electric shock or fire;
- periodically examine the cord (AC adaptor) of your appliance, and if its appearance
indicates damage or deterioration, unplug it, discontinue use of the appliance, and have
the cord replaced with an exact replacement part by an authorized service center;
- protect the power cord (AC adaptor) from physical or mechanical abuse, such as be
-
ing twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention
to plugs, wall outlets, and the point where the cord exits the appliance. To disconnect
power from the mains, pull out the mains cord plug. When installing the product, ensure
that the plug is easily accessible;
- do not install this equipment in a confined space such as a book case or similar unit,
near stoves, fireplaces, heaters, radiators;
- after removing the battery from the unit, put it in a safe place where it will not get
into the hands of small children and accidentally swallowed; If accidentally swallowed,
consult with immediately;
- never charge batteries, try to take batteries apart, or allow batteries to become short
-
ed. Never expose batteries to direct heat or dispose of them by incineration; misuse of
batteries can cause them to leak and damage nearby items, and can create the risk of
fire and personal injury;
- always make sure that the battery’s positive and negative ends are facing correctly when
you load it into the unit; use only the type of battery specified for this unit in this manual.
- never dispose of the unit by burning it. Doing so can cause certain components to
suddenly burst, creating the risk of fire and personal injury;
- all electrical and electronic products should be disposed of separately from the mu
-
nicipal waste stream via designated collection facilities appointed by the government or
the local authorities;
- for more detailed information about disposal of your old appliance, please contact
your city office, waste disposal service or the shop where you purchased the product;
- the displays and illustrations (such as key markings) shown in this User’s Manual are for
illustrative purposes only, and may differ somewhat from the actual items they represent;
- the contents of this manual are subject to change without notice.
- in no event shall Uniel Lighting Co. Ltd. be liable to anyone for special, collateral, inci
-
dental, or con sequential damages in connection with or arising out of the purchase or
use of these materials. Moreover Uniel Lighting Co. Ltd. shall not be liable for any claim
of any kind whatsoever against the use of these materials by any other party.
IMPORTANT SAFEGUARDS
STARTING
• The instruction manual contains important operating and maintenance instructions.
For your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct sunlight, too high or low temperature
or humidity.
• If you are not going to use the unit within a long period of time, remove the
batteries to avoid their leakage.
• Do not disassemble the unit yourselves. Refer servicing to qualified service personnel
BUTTONS
1. Alarm ON indicator
2. PM indicator (12HR mode)
3. Temperature display
4. Al on/off set button
5. Hour set button
6. Minute set button
7. Alarm set button
8. 12/24 Hr switch
9. Battery compartment
10. Power socket
11. Hanging hole
Remote hand-set
12.Temperature/Snooze/alarm button
13. Hour set button
14. Fº/ t°C Alarm on/off button
15. Time set button
16. Minute set button
17. Battery compartment.
•
To operate clock
When the clock is plugged in, the display will blink on and off meaning the incorrect time is be
-
ing displayed. You should always check the time when this is indicated.
When the Alarm indicator is on, the alarm will sound at the time set.
•
Set the time
Press the HOUR button (5) until the correct hour is set, press the MINUTE button(6) until the
correct minute is set.
•
Set alarm
Press and hold the ALARM set button (8) and the HOUR button (5) or MINUTE button (6) as
above. Be sure to set AM/PM property too.
•
Alarm on/off
Press the alarm ON/OFF button (4) to turn on or off the alarm. Alarm function is enabled when
the alarm indicator is on.
•
12/24 Hour selector
Slide the 12/24 switch (8) for 12-hour or 24-hour format.
•
Battery Back Up
Insert four “AA” size batteries into the battery compartment on the back-side of the clock. The
battery will hold the ALARM and TIME settings until power is restored. If there is no battery and
the power is interrupted, the display will flash and the alarm and the time will need to be reset.
•
To operate Remote hand-set
•
Battery installation
Unscrew the battery cover (15), insert one CR2032 button cell into the battery compartment
and reinstall the battery cover.
If the unit doesn’t work after being used for a period of time, You may need to replace the
battery.
•
Set time
Press the time button (13) and the HOUR button (11) until the correct hour is displayed, then
release the HOUR button (11) and press the MINUTE button (14) until the correct minutes
is displayed.
•
Set Alarm
Press and hold the SNOOZE / ALARM button (12) and the HOUR button (11) or MINUTE but
-
ton(16) as above.
•
Alarm on/off
Press the ALARM ON/OFF button (14) to turn on or off the alarm. Alarm function is enabled
when the alarm indicator is on.
•
Snooze
When the alarm sounds, press the SNOOZE/ALARM button (10) to get an extra 8-9 minutes of
sleep. This can be repeated up to six times within an hour.
•
View thermometer
The lower part of front lens displays thermometer. Press C’/F’/Alarm on/off button (14) to select
Centigrade or Fahrenheit for thermometer.
•
Specification
Power source 220V/50Hz
Remote control battery 1xCR 2032
Operating no more than 3m
Power source 4 x 1,5V (not included)
Temperature range -10°C+60°C( 14°F-140°F)
Adaptor 9V(12V)~500mA
Item size 280x280x28mm
Dangerous!
This lighting flash with arrow head symbol within an equilateral tri-
angle is intended to alert the user to the presence of uninsulated dan-
gerous voltage within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
Caution!
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance (ser-
vicing) instructions in the literature accompanying the product.
SAFETY PRECAUTIONS
HOUR
MINU
TE
o
o
C / F
ALARM
ON/OFF
TIME
TEMPERA
TURE
SNOOZE/
ALARM
24H 12H
ALARM
MINUTE
HOUR A
L ON/OF
F
4. Al on/off set button
11. Hanging hole
Remote hand-set
5. Hour set
button
6. Minute set button
7. Alarm set button
8. 12/24 Hr switch
9. Battery compartment
10. Power socket
12. Temperature/Snooze/alarm button
13. Hour set button
14. Fº/ t°C Alarm
on/off button
15. Time set button
16. Minute set button
17. Battery compartment
1. Alarm ON indicator
2. PM indicator
(12HR mode)
3. Temperature display
