To Avoid this Memory Effect
At least once a month, operate the unit until the
“Battery Low” indicator appears. Then recharge
the battery for a full 15 - 20 hours. Avoid putting
the handset back in the base after using the phone
for a short time. This could cause “topping off”
the charge.
Low Battery Indicator
When the battery
pack in the handset is
very low and needs to
be charged, the
talk/batt low
LED flashes.
If the
talk/batt low
LED begins to flash, the phone is
programmed to eliminate its functions to save
power. The table below describes how to return
your phone to normal operation.
During a Call
In Standby Mode
Only the
T
button operates.
None of the buttons will operate.
The handset beeps and the
talk/batt low
LED flashes once
every 3 seconds.
The handset
talk/batt low
LED
flashes once every 3 seconds.
Complete your call as quickly
as possible.
You will not be able to make a
call.
Return the handset to the base
for charging.
Return the handset to the base
for charging.
Note:
Allow 15 to 20 hours without any
interruption for the handset to fully recharge.
Setting the Pulse/Tone Switch
Be sure the
PULSE/TONE
switch
is in the
TONE
position.
Note:
Most phone systems are tone dialing. Check
with your local phone company if you are not
sure whether your system is tone or pulse dialing.
Adjusting Ringer Controls
To adjust the ringer volume of your handset,
press
G
when the phone is not in use.
You can also select one of two different ringer
tones for the handset.
Press
G
to select a different ringer tone when
the phone is not in use.
Adjusting Handset Receiver Volume
Volume settings are “normal” and “high.” When
the handset is first picked up, the volume will be
at the “normal” setting. Pressing the
V
will
change the volume to “high.” This can be done
during a call.
Automatic Digital Code Security
To avoid unauthorized calls on your phone, a
digital code feature was added to all
XC800 Series
phones. This digital code is shared only between
the handset and base. The code is set
automatically
when you first use the phone.
To change the digital code, be sure the handset is
on the base, then:
1. Press the
page/find
button on the base.
2. After the handset stops beeping, remove it
from the base.
3. Wait 5 seconds, then place the handset on
the base.
4. The
status
LED blinks to indicate that the digital
security code is set.
If the base loses power while the handset is off
the base, the digital code may be erased. When
this happens, the handset will not function. To
reestablish communication between the handset
and base:
1. Restore power to the base.
2. Place the handset back on the base.
3. The
status
LED will blink to indicate that the
digital security code is set.
8
H:...folded xc800series.vp
Thu Jul 09 15:07:50 1998
Color profile: Disabled
Composite Default screen
Содержание XC815
Страница 1: ......
