5
Troubleshooting
52
Changing the Handset to Base Code
Your phone ships with a special identification code to connect any registered handsets to this particular base.
Normally,.you.will.never.have.to.change.this.handset.to.base.code,.but.in.the.rare.situation.that.you.suspect.another.
cordless.telephone.is.using.the.same.code.or.if.you.are.instructed.to.change.this.code.by.a.manufacturer’s.Call.
Center.Representative,.you.can.change.the.code..To.change.the.handset.to.base.code:
Reset.all.of.your.handsets.(see.Resetting.the.Handset.on.page.50).
Re-register.each.handset.(see.Registering.accessory.handsets.on.page.2).
Changing the Line Mode for Multiple Extensions
Line.mode.refers.to.the.method.that.telephones.use.to.signal.each.other.that.an.extension.is.in.use..Customer.
service.may.recommend.changing.the.line.mode.if.you.have.any.of.the.following.problems:
Your.phone.keeps.ringing.after.someone.answers.on.an.extension.phone.
Caller ID displays briefly and then clears.
Press.
[menu/select]
..
Select.the.GLOBAL.SETUP.menu,.and.then.the.SET.LINE.MODE.submenu..
IF.INSTRUCTED.BY.CUSTOMER.SERVICE.PRESS.[SELECT].appears..Press.
[menu/select]
.
Move.the.cursor.to.select.TYPE.-.A,.TYPE.-.B,.or.OFF.
Press.
[menu/select]
. You will hear a confirmation tone.
Traveling Out of Range
When.the.handset.is.in.standby,.the.handset.will.display.OUT.OF.RANGE.
During.a.call,.if.you.move.your.handset.too.far.from.your.base,.noise.may.increase..If.you.pass.the.range.limit.of.the.
base,.the.handset.will.beep,.display.OUT.OF.RANGE,.and.then.go.to.standby..The.base.will.maintain.the.connection.
for.thirty.seconds.after.the.handset.goes.out.of.range..If.you.move.the.handset.back.within.range.of.the.base.within.
thirty.seconds,.press.
[
/flash]
.or.
[
]
.to.pick.up.the.call.again.
)
2)
•
•
)
2)
3)
4)
5)
Содержание TRU9565-2 - TRU Cordless Phone
Страница 1: ...81 1 25 66 7 3 21 6 758 6 5 6...