[ 14 ] G E T T I N G S TA R T E D
D. Choose the dialing mode
Most phone systems use tone dialing, which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) When the phone is in the standby mode, press
menu/mute
.
2) Press
-
to move the pointer to “
Dial Mode
”.
3) Press
select/ch
and the display will show the current setting.
(The initial setting is Tone.)
4) Press
+
or
-
to change the selection.
5) Press
select/ch
and a confirmation tone will sound.
6) Press
end
to exit.
Throughout this manual, terms such as Standby and Talk Mode are used. Below is the
terminology explanation.
Standby Mode
- The handset is not in use, is off the base, and
talk/flash
has not been
pressed. A dial tone is not present and the display is blank.
Talk Mode
- The handset is not on the base and
talk/flash
has been pressed enabling a dial
tone. “
Talk
” appears on the display.
Terminology
• If you are not sure of
your dialing system,
set the unit to tone
dialing. Make a trial
call. If the call
connects, leave the
setting as is,
otherwise set the unit
to pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
DTMF tones in certain
situations during a
call, you may
“switch-over” to tone
dialing. (Refer to
“Tone Dialing Switch-
over” on page 22.)
UC777BH(TRU4485) OM 4/9/02 1:45 PM Page 14
Содержание TRU4485 Series
Страница 1: ......
Страница 2: ...UC777BH TRU4485 OM 4 9 02 1 45 PM Page ii...
Страница 3: ...www uniden com UC777BH TRU4485 OM 4 9 02 1 45 PM Page 1...
