the microphone on the radio. (The
tx
icon displays
while you are transmitting. Pause slightly after
pressing the
PTT
button before you start talking to
prevent cutting off your transmission.)
2. When you are finished speaking, release the
PTT
button. You can now receive incoming calls. While
receiving, the
rx
icon displays.
Transmitting a Call Alert Tone
Your radio is equipped with a call tone that transmits
when the
CALL/MON
key is pressed. You can select from
10 call tones.
1. Press
MENU/
until
call
displays on the screen
and the call tone number displays.
2. Press ▲ or ▼ to cycle through the call tones. A
sample of the tone sounds as you move through
them
3. The radio returns to its normal state after about 5
seconds.
To transmit the call tone, press the
CALL/MON
key.
Auto Squelch Feature
The radio is equipped with an automatic squelch
system which shuts off weak transmissions and
unwanted noise due to terrain conditions or range
limitations.
Monitor Mode Feature
Your radio allows you to listen for weak signals on the
current channel at the press of a key.
To turn ON monitor mode:
Press and hold
CALL/MON
for 2 seconds. On a
channel that does not have activity, you will hear only
an open-squelch hissing noise and
rx
displays.
To turn OFF monitor mode:
Press the
CALL/MON
key for 2 seconds again.
rx
does
not display.
Weather Channels
Your radio can access 7 NOAA weather channels and
you can select one of these channels to be monitored
while you are listening to GMR transmissions. When
weather alerts are broadcast on that channel, the radio
tunes to that channel so you can hear them.
While you are listening to weather channels, the radio
does not receive GMRS communications.
1. To access the weather channels, press
WX/LOCK
.
The weather channel number and the
icon
display.
2. Press
CH/
. The weather channel number
flashes.
3. Press ▲ or ▼ to manually cycle through the
weather channels.
4. If there is a weather channel you want to
Operating
Frequency
UHF 462.5500 - 467.7125 MHz
Power
Source
3 AA NiMH Batteries
per radio.
FCC INFORMATION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Important: Changes or modifications to this unit not
expressly approved by Uniden could void your
authority to operate this unit. Your radio is set up to
transmit a regulated signal on an assigned frequency.
It is against the law to alter or adjust the settings
inside the radio to exceed those limitations. Any
adjustments to your radio must be made by qualified
technicians.
To be safe and sure:
• Never open your radio’s case.
• Never change or replace anything in your radio
except the batteries.
Your radio might cause TV or radio interference even
when it is operating properly. To determine whether
your radio is causing the interference, turn it off. If the
interference goes away, your radio is causing it. Try to
eliminate the interference by moving your radio away
from the receiver. If you cannot eliminate the
interference, the FCC requires that you stop using the
radio.
Hazardous Environments: Do not operate the radio in
hazardous environments. Explosion or fire may result.
Do not operate the radio near unshielded electrical
blasting caps.
Under certain conditions, radios can interfere with
blasting operations and may cause an explosion. Turn
your radio OFF to prevent accidental transmission
when in a blasting area or in areas posted: "Turn off
two-way radio." Construction crews often use remote
control RF devices to set off explosives.
Care and Safety: To clean the radio, use a soft cloth
dampened with water. Do not use cleaners or solvents
because they can harm the body of the unit and leak
inside, causing permanent damage. Use a dry, lint-
free cloth to clean the battery contacts. Do not
submerge the unit in water. If the unit gets wet, turn it
off and remove the batteries immediately.
Dry the battery compartment with a soft cloth to minimize
potential water damage. Leave the battery compartment cover off
overnight to ensure complete drying. Do not use the radio until
the unit is completely dry.
FCC RF EXPOSURE INFORMATION
WARNING!
Read this information before using the radio.
In August 1996 the Federal Communications Commission (FCC)
of the United States with its action in Report and Order FCC
96-326 adopted an updated safety standard for human exposure
to radio frequency electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the
safety standard previously set by both U.S. and international
standards bodies. The design of the radio complies with the FCC
guidelines and these international standards. Never allow children
to operate the radio without adult supervision and the knowledge
of the following guidelines.
WARNING! It is up to the user to properly operate this radio
transmitter to insure safe operation. Please adhere to the
following: Use only the supplied or an approved antenna.
Unauthorized antennas, modifications, or attachments could
impair call quality, damage the radio, or result in violation of FCC
regulations.
Do not use the radio with a damaged antenna. If a damaged
antenna comes into contact with the skin, a minor burn may
result. Please contact your local dealer for a replacement
antenna.
Body-worn Operation
This device was tested for typical body-worn operations using the
supplied belt-clip. To maintain compliance with FCC RF exposure
requirements, Body-worn operations are restricted to the supplied
belt-clip. For hand-held operation, the radio should be held 1 inch
from the user's face. The use of accessories that do not satisfy
these requirements may not comply with FCC RF exposure
requirements and should be avoided. For more information about
RF exposure, please visit the FCC web site at: www.fcc.gov.
(C) improperly installed, (D) serviced or repaired by someone other than an
authorized Uniden service center for a defect or malfunction covered by this
warranty, (E) used in any conjunction with equipment or parts or as part of
any system not manufactured by Uniden, or (F) installed or programmed by
anyone other than as detailed by the owner’s manual for this product.
designate as the weather alert channel, press
CH/
again. The channel numbers stop flashing.
5. Press
WX/LOCK
again. The radio returns to
normal mode and the
icon and
alt
display,
indicating there is a weather channel set to alert
mode.
You can only manually cycle through channels when
the channel numbers are flashing
Key Lock
1. Press and hold
WX/LOCK
;
displays. The
following functions are not affected by Key Lock:
• Volume adjust
• Enter monitor mode
• PTT transmission
• Backlight
• Power off
2. Press and hold
WX/LOCK
again;
disappears.
Backlight
Press and hold
CH/
to turn on the LCD backlight.
The screen stays illuminated for 10 seconds before
the backlight turns off.
FREQUENCY CHART
CH
Freq.[MHz] -
Cross Ref.
CH
Freq.[MHz] -
Cross Ref.
1
462.5625 - FRS &
GMRS 1
12
467.6625 - FRS 12
2
462.5875 - FRS &
GMRS 2
13
467.6875 - FRS 13
3
462.6125 - FRS &
GMRS 3
14
467.7125 - FRS 14
4
462.6375 - FRS &
GMRS 4
15
462.5500 - GMRS 11
5
462.6625 - FRS &
GMRS 5
16
462.5750 - GMRS 8
6
462.6875- FRS &
GMRS 6
17
462.6000 - GMRS 12
7
462.7125 - FRS &
GMRS 7
18
462.6250 - GMRS 9
8
467.5625 - FRS 8
19
462.6500 - GMRS 13
9
467.5875 - FRS 9
20
462.6750 - GMRS 10
10
467.6125 - FRS 10
21
462.7000 - GMRS 14
11
467.6375 - FRS 11
22
462.7250 - GMRS 15
Channels
15 GMRS/7 FRS
Weather
Channels
7
SPECIFICATIONS
© 2015 Uniden America Corporation
Issue 1, August 2015
All rights reserved
Printed in China
STATEMENT OF REMEDY: In the event that the product does not conform
to this warranty at any time while this warranty is in effect, warrantor will
either, at its option, repair or replace the defective unit and return it to you
without charge for parts, service, or any other cost (except shipping and
handling) incurred by warrantor or its representatives in connection with the
performance of this warranty. Warrantor, at its option, may replace the unit
with a new or refurbished unit.
THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND
ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF
AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE
WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY
OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE.THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE
REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or
limitation of incidental or consequential damages so the above limitation or
exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state. This warranty is
void outside the United States of America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after
following the instructions in the owner’s manual you are certain that the
Product is defective, pack the Product carefully (preferably in its original
packaging). The Product should include all parts and accessories originally
packaged with the Product. Include evidence of original purchase and a note
describing the defect that has caused you to return it.The Product should be
shipped freight prepaid, by traceable means, to warrantor:
Uniden America Corporation
C/O Saddle Creek
743 Henrietta Creek Road, Suite 100
Roanoke, TX 76262
(800) 297-1023, 8 a.m. to 4:30 p.m., Central, Monday through
Friday
For body worn operation, this handset has been tested and meets
ONE YEAR LIMITED WARRANTY
Important: SAVE YOUR RECEIPT! Evidence of original purchase
is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original
retail owner, this Uniden Product to be free from defects in materials and
craftsmanship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate
and be of no further effect 12 months after the date of original retail sale.
The warranty is invalid if the Product is: (A) damaged or not maintained as
reasonable or necessary, (B) modified, altered, or used as part of any
conversion kits, sub-assemblies, or any configurations not sold by Uniden,
the Industry Canada RF exposure guidelines when used with the
(manufacturer name ) accessories supplied or designated for this
product. Use of other accessories may not ensure compliance with
Industry Canada RF exposure guidelines.
Instruction manual shall include the following or similar
statement:
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are de signed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed an d used in
accord ance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
