Uniden PRO 510XL, Инструкция по эксплуатации

Страница: 6 / 12

Sheet 1 Page 6
INSTALLATION
Connect the microphone
Align the microphone connector with the jack on the front of the radio. Push
the connector in firmly and secure it with the locking screw.
Connect the power
You can connect the radio to any standard 12 volt DC power source, with
either a positive or negative ground. If you don’t know whether your power
supply uses a positive or negative ground, consult the manual for your power
supply or contact the manufacturer.
WARNING! DO NOT connect this equipment to a power supply if you are
not absolutely certain of the grounding type!
1) Make sure your power supply is turned off.
2) For power supplies with a NEGATIVE ground, connect the RED lead
on the radio to the power supply’s POSITIVE (+) pole, and connect the
BLACK lead to the power supply’s NEGATIVE (–) pole or to a neutral
ground such as the chassis.
OR
For power supplies with a POSITIVE ground, connect the BLACK lead on
the radio to the power supply’s NEGATIVE (–) pole, and connect the RED
lead to a neutral ground such as the chassis.
3) Turn on your power supply.
4) Turn the radio’s
Volume
knob clockwise to power on the radio.
Installing the mounting bracket
When choosing the location for the radio’s mounting bracket, keep the
following things in mind:
► Pick a location that does not block your view, interfere with your vehicle’s
controls, or hinder your driving.
► Make sure the radio and microphone are not in front of an airbag.
► Pick a solid surface that can support the weight of the bracket and the
radio.
► Make sure there’s enough room. (You may want to put the radio in the
bracket when you’re choosing where to install the bracket.)
Once you choose the location, use the included, self-tapping screws to attach
the mounting bracket and the microphone bracket to your vehicle (you don’t
have to drill holes). Slide the radio into the bracket and use the included knobs
to hold it at the preferred angle.