E-10
Uniden MHS125 Radio Owner’s Manual
Scan mode operation
You can save channels into memory and then use scan
mode to monitor those channels from lowest to highest. If the
radio detects a signal on a channel, it stays on that channel
as long as the signal is received; when the signal stops, the
radio continues scanning.
Using the radio in scan mode
To activate scan mode, press
Scan-Dual
.
You must have at least two channels in memory to start a
scan.
You cannot transmit while in scan mode.
To save a channel into memory, select the channel, then
press the
MEM-SOS
button. The
MEM
icon displays
whenever you tune to that channel.
To remove a channel from memory, set the radio to that
channel, then press the
MEM-SOS
button. The
MEM
icon
no longer displays.
When the radio stays on a channel, press
Channel Up
to
leave that channel and resume scanning.
To end the scan, press the
Scan-Dual
button again; the
radio remains on the last scanned channel.
11
10
08
13
12
14
17
15
The radio scans about
5 channels in 0.5 seconds.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up
button or the signal stops.
Resume
scan
11
10
08
13
12
14
17
15
The radio scans about
5 channels in 0.5 seconds.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up
button or the signal stops.
Resume
scan
