Uniden GDVR 10 Series, Руководство пользователя

Страница: 57 / 66

57
After turning on, the DVR cannot switch on normally.
Possible reasons:
•
The power supply is not correct.
•
Switch power cable is not in good connection.
•
Switch power is damaged.
•
The program upgrading is wrong.
•
The hard disk is damaged or something is wrong with the hard disk cables.
•
Something is wrong with the front panel.
•
The main board of the DVR is damaged.
The DVR reboots automatically or frequently stops working after
booting up for a few minutes
Possible reasons:
•
The input voltage is not stable or too low.
•
The hard disk is damaged or the hard disk cables are broken.
•
The power rating from wall supply is not correct.
•
The front-end video signal is not stable.
•
Poor heat dissipation, too much dust, bad running environment for the
DVR.
•
Something is wrong with the hardware of the DVR.
Cannot detect hard disk after switch on.
Possible reasons:
•
The hard disk power supply cable is not connected.
•
The cables of the hard disk are damaged.
•
The hard disk is damaged.
•
The SATA port of the main board is damaged.
TROUBLESHOOTING