Using your phone
PAUSE
During the memory storage procedure, you may wish to press the redial button to insert
a pause between numbers. (This is sometimes useful for accessing a switch board,
telephone banking or long distance dialling).
Pressing the redial button more than once will increase the pause between digits.
Each time the redial button is pressed, a ‘P’ will show on the LCD to indicate a 2 second
pause in the dialling sequence. Each pause counts as one digit.
For options 3 & 4, the LCD will show <EMPTY> if there is no number
stored in the memory button pressed.
CHAIN DIALING
On certain occasions (such as telephone banking), after dialing one number, you may
wish to dial another number without hanging up. This is known as chain dialling or cascade
dialling.
Simply store the second number in another memory location and press the corresponding
speed dial button when required. In this way you can recall both numbers that are stored
into their own memory locations at the relevant times.
CALL TIMER
Approximately 10 seconds after the handset is picked up,
or the speaker button is pressed, the call counter will
begin and show the elapsed time on the display screen.
LCD BACKLIGHT DISPLAY
The LCD has a back light that will turn on under the
following conditions;
•
Any incoming call
•
Picking up the handset
•
Pressing any button
The backlight will switch off automatically approximately 15 seconds after the
last activity. The back light will not work if the AC adaptor is switched off,
disconnected or there is a power cut.
DIALING THE STORED NUMBERS
There are four different ways to dial a stored speed dial number, depending on your
preference.
1.
Pick up the handset and press the desired speed dial button (1 ~ 12).
2.
Press the speaker button and then press the desired speed dial button (1 ~ 12).
3.
Press the desired speed dial button (1 ~ 12), and check the LCD shows the
If you have selected a speed dial button that does not have a stored
number, the telephone will not dial.
18
NOTE
NOTE
caller display
correct information then press the
dial
button (the phone enters speakerphone
mode and dials the displayed number).
4.
Press the desired speed dial button (1 ~ 12), and check the LCD shows the
correct information then pick up the handset and then press the
dial
button.
