Setting Up and Adjusting Your Phone
SETTING UP
DESK/TABLETOP INSTALLATION
1) Plug the AC adapter cord into the 9 VDC input jack on the
back of the base.
2) Wrap the AC adapter cord around the strain relief notch.
Place the power cord so that it does not create a trip
hazard or where it could become chafed and create a fire
or electrical hazard
.
3) Plug the AC adapter into a standard 120 VAC wall outlet.
4) Charge the battery (refer to “Charging the Battery Pack,”
page 6).
5) Plug one end of the long telephone cord into the
TEL LINE
jack on the back of the base.
6) Plug the other end of the cord into your telephone jack on
the wall.
7) Place the base on a desk or tabletop.
Then, place the handset into the base as
shown.
In desk/tabletop installation, the handset is
designed to stand vertically in the base.
When using on a flat surface,
DO NOT
lay
the handset down on the base.
8) Raise the base antenna to the
vertical position.
3
AND
ADJUSTING
YOUR
PHONE
SETTI
NG
UP
SETTING
UP
Use only the Uniden AC adapter supplied with this phone.
DO NOT use an outlet controlled by a wall switch.
TIP
Before choosing a location
for your phone, read the
“Installation Considerations”
included in the “Precautions
and Important Safety
Instructions” brochure.
