Uniden Elite 9135, Руководство пользователя

Страница: 29 / 32

27
Plug the filter into the telephone wall jack and plug the base into the
filter. Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe
it off and use as normal. If you can hear liquid inside the housing:
Remove all compartment covers, and disconnect all cables and 1.
cords.
If liquid is leaking from any vent or hole, turn the phone so that vent
2.
faces down. If not, place the largest vent face down.
Let dry for at least 3 days. Check for liquid inside the phone before 3.
replacing compartment covers and reconnecting cords.
Resetting Handsets
The base can register up to 10 handsets. If you have trouble with a
handset or if you want to replace one, clear the registration information
from the base and the handset:
Press and hold 1.
end
and # at the same time until you see the
System
Reset menu.
If you still have the base the handset is registered to, select 2. Deregister
HS , then select the handset you want to reset. If you don’t have that
base anymore, select
Base Unavailable
.
To confirm, select 3.
Yes
. The handset displays
Handset not registered
.
Registering Handsets
If you see a “not registered” message on a handset, you must register it
to a base before using it.
Place the handset in the base; the display should say 1.
Handset
Registering .
Wait until the display says 2. Registration Complete (about 30 seconds),
then pick up the handset; press
Home/FlasH
.
If you don’t hear a dial tone or the display says
# Registration Failed
,
charge the battery completely, then try again.
Elite9135om_20110115.indd 27 15/2/11 4:23:58 PM