Compliance Information
Any changes or modifications to this product not expressly approved by the manufacturer
or other party responsible for compliance could void your authority to operate this product.
FCC Part 15 Information
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation. Privacy of communications may not be ensured when using this phone.
FCC PART 15.105(b):
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
x
Reorient or relocate the receiving antenna.
x
Increase the separation between the equipment and receiver.
x
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
x
Consult the dealer or an experienced radio/TV technician for help.
rF exposure Information
This product complies with FCC radiation exposure limits under the following conditions:
x
The base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all
persons during normal operation.
x
The base must not be collocated or operated in conjunction with any other antenna or trans-
mitter.
x
The headset is designed for body-worn operation and meets FCC RF exposure guidelines when
used with any belt clip, carrying case, or other accessory supplied with this product. (All nec-
essary accessories are included in the package; any additional or optional accessories are not
required for compliance with the guidelines.) Third party accessories (unless approved by the
manufacturer) should be avoided as these might not comply with FCC RF exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment
Technical Specifications. This is confirmed by the registration number. The abbreviation
IC
before the registration number signifies that registration was performed based on a Decla-
ration of Conformity indicating that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked
on the equipment itself. The REN assigned to each terminal equipment provides an indica-
tion of the maximum number of terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination of devices subject only to
the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not
exceed 5.
Radio equipment
The term
IC
before the radio certification number only signifies that Industry Canada
technical specifications were met. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. "Privacy of com-
munications may not be ensured when using this telephone".
one-year Limited Warranty
Evidence of original purchase is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner,
this Uniden Product to be free from defects in materials and craftsmanship with only the
limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate and be of
no further effect 12 months after the date of original retail sale. The warranty is invalid if
the Product is (A) damaged or not maintained as reasonable or necessary, (B) modified,
altered, or used as part of any conversion kits, subassemblies, or any configurations not sold
by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an
authorized Uniden service center for a defect or malfunction covered by this warranty, (E)
used in any conjunction with equipment or parts or as part of any system not manufactured
by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner's
manual for this product.
STATEMENT OF REMEDY: In the event that the product does not conform to this warran-
ty at any time while this warranty is in effect, warrantor will either, at its option, repair or
replace the defective unit and return it to you without charge for parts, service, or any other
cost (except shipping and handling) incurred by warrantor or its representatives in connec-
tion with the performance of this warranty. Warrantor, at its option, may replace the unit
with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE
SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU
OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER,
WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING,
BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR
PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSE-
QUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental
or consequential damages so the above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state. This warranty is void outside the United States
of America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following
the instructions in the owner's manual you are certain that the Product is defective, pack
the Product carefully (preferably in its original packaging). Disconnect the battery from the
Product and separately secure the battery in its own separate packaging within the shipping
carton. The Product should include all parts and accessories originally packaged with the
Product. Include evidence of original purchase and a note describing the defect that has
caused you to return it. The Product should be shipped freight prepaid, by traceable means,
to warrantor at:
Uniden America Service
4700 Amon Carter Blvd.
Fort Worth, TX 76155
x
Uniden® is a registered trade-
mark of Uniden America
Corporation.
x
Call waiting, CID, CIDCW,
and Voice Mail are telephone line services. Your phone supports these
services, but you have to arrange for them through your telephone pro-
vider. Contact your provider for details.
x
The pictures in this manual are for example only. Your phone may not look exactly like the
pictures.
As an Energy Star® Partner, Uniden
has determined that this product
meets the Energy Star® guidelines for
energy efficiency. Energy Star® is a U.S.
registered mark.
© 2012 Uniden America Corp.
Printed in Vietnam
Fort Worth, Texas
U01UU260BZA(0)
