– 6 –
I.C. Notice
TERMINAL EQUIPMENT
NOTICE:
This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is confirmed by
the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based
on a Declaration of Conformity indicating that Industry Canada
technical specifications were met. It does not imply that Industry
Canada approved the equipment.
NOTICE:
The Ringer Equivalence Number (REN) for this terminal
equipment is marked on the equipment itself. The REN assigned to
each terminal equipment provides an indication of the maximum
number of terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not exceed five.
RADIO EQUIPMENT
The term “IC:” before the radio certification number only signifies
that Industry Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device. “Privacy of communications may not be
ensured when using this telephone”.
• If you press
end
before the answering system answers, the
phone will return to the standby mode.
• When the answering system does not answer within 6 seconds,
you will hear a beep and the phone will return to the
standby mode.
• When you receive a call, the remote operation is canceled.
To playback a message
Press the
soft key.
To skip a message
Press the
soft key.
To repeat the current message
Press the
soft key after four seconds.
To repeat the previous message Press the
soft key within four seconds.
To delete a message
Press the
DELETE
soft key.
To stop operation
Press
end
.
DCX520_UU820BH UU01820BZ_1 1/16/03 9:59 AM Page 6
