Uniden 7100A, Руководство по эксплуатации

Страница: 18 / 21

REMOTE OPERATION
35
USING REMOTE COMMANDS
To use the remote commands, you must enter the remote oper-
ation security code within 8 seconds after the DTAM answers
the call. After the DTAM beeps once to verify you entered the
code correctly, enter the number(s) for the function(s) you
want the DTAM to perform.
Press To
00 Turn the DTAM off. The DTAM beeps and announces "Answer Off".
01 Turn the DTAM on. The DTAM beeps and announces "Answer on"
then plays OGM1. If no OGM1 is recorded, the DTAM beeps
and announces "You have no announcement one".
02 Set the DTAM to answer with OGM2 announcement. The DTAM
beeps and announces "Announce only", then plays OGM2. If no
OGM2 is recorded, the DTAM beeps and announces "You have no
announcement two".
2 Play all messages. If no message is recorded, the DTAM says
"You have no messages".
3 Play new messages. When new messages are recorded, the DTAM
announces the number of new messages before playback. If no
new message is recorded, the DTAM says, "You have no new
messages".
4 Monitor the room where the DTAM is installed. The room is
monitored for 20 seconds. Press 4 again for another 20 seconds.
You can repeat this for as long as you like.
51 Delete all messages (except new messages). Press 1 after the DTAM
announce "Erase messages", then the DTAM beeps.
34
REMOTE OPERA
TION
CHANGING THE REMOTE OPERATION SECURITY CODE
The remote operation security code is preset to 798, but you can
change it by following these steps.
1. Hold down
code set
until the DTAM beeps once. appears.
2. Press again. (security code) and the digits of the
current code appear in sequence, then the first digit reappears.
For example, when the security code is 798, the display shows
(security code) , , , then reappears.
3. Repeatedly press or to set the first digit, then
press . The second digit appears.
4. Press or to set the second digit, then press
The third digit appears.
5. Press or to set the third digit, then press
The DTAM sounds a long beep and announces the
security code.
REMOTE OPERATION
NOTE:
Be sure to set each digit within 8 seconds. Otherwise, you must start
over from Step 1.
REMOTE OPERA
TION
3653 Uniden 7100A Booklet 27/7/98 1:09 PM Page 34