Unicum Foodbox Touch Lift, Руководство пользователя

Страница: 12 / 59

FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH
Page 12 Version 1.3 / December 2018
ТМ
4.4.4 Lock
The vending machine is supplied with the RIELDA lock, which can be programmed for the required
key set that permits using one work key for several RIELDA locks at once, as well as easily change any
lock combination for the new work key in case of old key loss, theft or breakage.
figure 4
ATTENTIoN!
The lock programming operations should be executed with the vending machine door
open! otherwise, the door will be locked by a latch.
To return the lock to the programming position only use the master key, used for the
latest programming!
Reference notch
Closed
Open/programming
90
0
Master key Work keys
The lock is supplied together with three keys (fig. 4):
-one master key - a GOLDISH key used only for lock programming;
-two work keys - SILVERY keys used for the vending machine door opening/closing.
The lock may be in two positions:
-working position (“locked” position - fig. 4);
-programming position (“open” position - fig. 4).
The vending machine is supplied with a ready-programmed lock. To open/close the vending machine
door insert the SILVERY work key (sfig. 4) and turn it in the lock by 90° in the required position (fig. 4).
To program the lock for another work key (e.g. for using one work key for several vending machines
or in the case of the work key loss) it's necessary to execute the following operations with the vending
machine door OPEN:
-insert the master key («close» position - fig. 4), by which the lock was the last time programmed or
the one that was supplied with the lock (for initial programming), into the lock. Secure the master key in the
lock for at least 1 second. Then turn the key by 900 in the direction of the reference notch (fig. 4).
-while holding shutting off device of the door in order to avoid a spontaneous turn of the lock, remove
the master key from the lock and insert them into the new master key , which you want to program the
lock. If you want to program the lock on the same master key, don’t remove the master key from the lock.
-then turn the master key by 90° to the opposite direction («closed» position - fig. 4).
- take out the master key from the lock and put it in a safe place. To open/close the lock use the work
keys supplied with your new master key.